Aneroid (or clock face) devices which also depend on auscultation are gaining popularity, as are devices which depend on oscillation. Oscillatory devices produce a digital readout and work on the principle that blood flowing through an artery between systolic and diastolic pressures causes vibrations in the arterial wall which can be detected and transduced into electrical signals
With an oscillatory device, a cuff is inflated over the upper arm or wrist. The new models use “fuzzy logic” to decide how much the cuff should be inflated to reach a pressure about 20 mm Hg above systolic pressure for any individual. When the cuff is fully inflated to this pressure, no blood flow occurs through the artery. As the cuff is deflated below the systolic pressure, the reducing pressure exerted on the artery allows blood to flow through it and sets up a detectable vibration in the arterial wall
When the cuff pressure falls below the patient’s diastolic pressure, blood flows smoothly through the artery in the usual pulses, without any vibration being set up in the wall. Vibrations occur at any point where the cuff pressure is sufficiently high that the blood has to push the arterial wall open in order to flow through the artery.
The vibrations are transferred from the arterial wall, through the air inside the cuff, into a transducer in the monitor that converts the measurements into electrical signals.
These digital devices deflate at about 4 mm Hg per second, making them sometimes seem slower to use than auscultatory aneroid devices, but they are more accurate.